CRUISE CONTROL
ACTUATOR LINK-SETTING - V8i
Service repair no - 19.75.21
Link - adjust
3. Remove link from actuator.
4. Rotate socket joint adjuster as necessary.
NOTE: Setting procedure is carried out at
minimum throttle condition only.
5. Refit link to actuator and recheck clearance
between link and lever.
6.
With throttle fully open, check a gap of at least
3mm exists between side of link ("A" in
illustration) and side of small spring ("B" in
illustration). Realign link by bending to achieve
correct gap. Recheck clearance at closed
throttle/open throttle. Check link slides smoothly
in groove of throttle lever.
1.
2.
Ensure ignition is switched ’OFF’.
Check clearance between inside edge of
actuator link and recessed diameter of throttle
lever. Clearance should be 0.2 to 2.0 mm.
REPAIR
5
| Categories | Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1998 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)