Mpi
CRANKSHAFT REAR OIL SEAL
Service repair no - 12.21.20
Remove
Refit
1. Clean seal seating area of block and accessible
area of sump gasket. Sump gasket must be
replaced if damaged.
2.
Lubricate oil seal sealing surfaces with engine
oil.
1.
2.
3.
4.
5.
Remove gearbox.
Remove clutch assembly.
Remove flywheel.
Drain engine oil.
Fit sump plug, replacing sealing washer if
damaged and tighten to the correct torque.
Loosen 15 sump bolts by approximately 3 turns,
allowing sump to drop away from rear oil seal
housing. Do not loosen 3 bolts A around oil
pump housing.
3. Fit tool LRT-12-061 over crankshaft boss and fit
oil seal and housing assembly.
4. Remove tool.
6.
5.
Fit and tighten seal housing bolts to correct
torque in sequence shown.10Nm
7.
Remove bolts securing oil seal housing, remove
seal and housing assembly.
6.
Tighten sump bolts to correct torque and in the
correct sequence. See Engine Sump Gasket
Fit flywheel.
Fit clutch assembly.
Fit gearbox.
7.
8.
9.
REPAIR
5
| Categories | Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1998 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)