Tdi
Refit
42.
Apply Hylomar to mating faces of bell housing.
Lubricate splines of gearbox primary pinion with
Rocol MV 3.
If automatic transmission, coat the four drive
plate to torque convertor bolts with Loctite 290.
Tighten to 39 Nm.
43.
44.
Lower engine and locate with transmission.
If manual transmission locate primary pinion into
clutch and engage bell housing dowels. Fit
engine to bell housing fixings. Tighten to 40 Nm.
If automatic transmission fixings. Tighten to 46
Nm.
Raise engine, refit front engine mounting
brackets to cylinder block and bell housing.
Remove gearbox support and lower engine.
Tighten front engine mountings to chassis
fixings. Tighten to 45 Nm.
45.
46.
37.
38.
Remove nuts and plain washers securing front
engine mountings to chassis,and lift both engine
mounting bracket assemblies from vehicle.
Remove engine to bell housing fixings. Leave
starter motor attached.
47.
Reverse removal procedure. 1 to 37.
39.
40.
Raise engine to separate from transmission.
Check all connections to engine have been
disconnected.
41.
Remove engine.
REPAIR
5
| Categories | Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1998 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)