51
REAR AXLE AND FINAL DRIVE
Refit
10.
18. Fit brake caliper. Tighten to 82 Nm.
Secure brake pipes to axle casing.
19. If applicable, set ABS brakes sensor.
Push sensor in until it touches sensor ring then
rotate hub to set sensor.
20. Fit road wheel, remove axle stands and final
tighten road wheel nuts to 126 Nm.
21. Operate footbrake to locate brake pads before
driving vehicle.
Clean stub axle. Retract ABS sensor slightly
from sensor sleeve, if applicable
Fit hub assembly to stub axle.
Fit spacing washer.
Fit hub adjusting nut. Tighten to 61 Nm.
Back off adjusting nut 90°. Tighten to 4 Nm.
This will give the required hub end float of
0,010mm
11.
12.
13.
14.
Fit a new lock washer.
15.
16.
Fit locknut. Tighten to 61 Nm.
Tab over lock washer to secure adjusting nut
and locknut.
17.
Using a new joint washer fit axle shaft to hub,
secure with five bolts. Tighten to 65 Nm.
4
REPAIR
| Categories | Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1998 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)