12
ENGINE
DRIVE BELT RENEW
COMPRESSOR DRIVE BELT
Service repair no - 86.10.02
Remove
Service repair no - 86.10.03
NOTE: If cast lines on tensioner arm and
tensioner spring case are aligned, a new
drive belt must be fitted.
1. Remove auxiliary drive belt. See Drive Belt
Renew
Remove
2. Remove compressor shield.
3.
Loosen tensioner retaining bolts.
1.
2.
Remove fan cowl upper.
Apply ring spanner to tensioner pulley retaining
bolt.
4. Remove compressor drive belt. Mark direction
on belt if refitting.
3.
4.
5.
6.
Turn spanner to release pulley tension from belt.
Detach belt from pulley.
Release tensioner.
Complete removal of belt. Mark direction on belt
if refitting.
Refit
5.
Fit compressor drive belt.
6.
Fit torque meter to centre of tensioner and apply
and hold a torque of 35 Nm. Tighten 3 tensioner
retaining bolts.
Refit
7.
7. Rotate crankshaft 2 full turns.
8.
Reapply and hold a torque of 35 Nm to
tensioner, then fully loosen and retighten 3
tensioner retaining screws to 25 Nm.
Reverse removal procedure.
2
REPAIR
| Categories | Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1998 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)