256
STARTING AND OPERATING
Tire Pressure Monitor System Tire/Wheel
Tire Pressure Monitor System/4–LO Mode — If
Equipped
When the 4–LO mode is selected , the chim e will not
sou nd until either: the vehicle speed is greater or equ al to
25 mph (40 km/ h) or the vehicle is taken out of the 4–LO
mode.
Rotation and Sensor Replacement — If Equipped
With the TPM System , if a road tire and wheel is rep laced
by the spare, the TPM system will detect the swap
autom atically (after the ignition has been cycled ) and
display SPARE SWAP DETECTED along with a chim e.
This could take up to 10 minu tes with vehicle speed
above 25 mph (40 km/ h).
The low tire pressu re warning messages (on the EVIC)
and the “Tire Pressu re Monitor Warning Light” will
continu e to be displayed until the tire pressu re has been
increased to the prop er operating pressu re.
The tire pressu re sensors must be retrained follow ing a
wheel rotation or sensor rep lacem ent. Refer to “EVIC —
Retrain Tire Sensors” in Section 3 for more inform ation. It
is necessary to program the EVIC with the new sensor(s)
or the new position of each sensor as it is rotated to a
different corner of the vehicle.
General Information
This device complies with part 15 of the FCC rules and
RSS 210 of Ind ustry Canad a. Operation is subject to the
follow ing cond itions:
If a wheel rotation is not follow ed by the retrain proce-
dure, the system will not prop erly inform you of the
correct vehicle location of a low or high tire pressu re.
•
This device may not cause harm ful interference.
| Categories | Jeep Liberty Manuals, Jeep Manuals |
|---|---|
| Model Year | 2004 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)