1999-2002 Land Rover Defender Workshop Manual

01
INTRODUCTION
3.
Position an axle stand under right hand axle
tube, carefully lower jack until axle sits securely
on both axle stands, remove trolley jack.
Before commencing work on underside of
vehicle re-check security of vehicle on stands.
Reverse procedure when removing vehicle from
stands.
DYNAMOMETER TESTING
The front and rear axles cannot be driven
independently.
4.
5.
WARNING: DO NOT attempt to drive
individual wheels with vehicle supported
on floor jacks or stands.
Raise rear of vehicle
Four wheel dynamometers
1.
2.
3.
4.
5.
Position cup of hydraulic arm under differential
casing.
Raise vehicle to enable axle stands to be
installed under left and right hand axle tubes.
Lower jack until axle sits securely on axle
stands, remove trolley jack.
Before commencing work on underside of
vehicle re-check security of vehicle on stands.
Reverse procedure when removing vehicle from
stands.
Provided that front and rear dynamometer rollers are
rotating at identical speeds and that normal workshop
safety standards are applied, there is no speed
restriction during testing except any that may apply to
the tyres.
Two wheel dynamometers
IMPORTANT: Use a four wheel dynamometer for
brake testing if possible.
If brake testing on a single axle rig is necessary it
must be carried out with propeller shaft to rear axle
removed, AND neutral selected in BOTH main
gearbox and transfer gearbox. When checking brakes,
run engine at idle speed to maintain servo vacuum.
If checking engine performance, the transfer box must
be in high range and propeller shaft to stationary axle
must be removed.
HYDRAULIC VEHICLE RAMP (FOUR POST)
Use only a drive ontype ramp which supports vehicle
on its road wheels. If a wheel-freecondition is
required, use a drive onramp incorporating a
wheel-freesystem providing support beneath axle
casings. Alternatively, place vehicle on a firm, flat floor
and support on axle stands.
TWO POST VEHICLE RAMPS
The manufacturer of LAND ROVER VEHICLES
DOES NOT recommend using ’Two Post’ ramps
that employ four adjustable support arms. These
are NOT considered safe for Land Rover vehicles.
If vehicle is installed on a Two Post ramp
responsibility for safety of vehicle and personnel
performing service operations is in the hands of
the Service Provider.
6
INFORMATION
Product Specification
CategoriesLand Rover, Land Rover Defender
Tags
Model Year1999, 2000, 2001, 2002
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 627 pages
Document TypeWorkshop Manual
LanguageEnglish
Product NameDefender
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field