1999-2002 Land Rover Defender Workshop Manual

ELECTRICAL
HEADLAMPS - ALIGN BEAM
Service repair no - 86.40.17
Check
SOLENOID/MOTOR - FRONT DOOR - ADJUST
Service repair no - 86.26.21
Adjust
1.
2.
Align suitable beam setting equipment to
headlamp.
Ensure headlamp height adjustment switch set
to ’O’ and headlamps switch on.
Headlamp setting = 1.2% below horizontal and
parallel.
1.  Remove door trim casing.  See  CHASSIS AND
BODY, Repair.
Adjust
3.
Align beam setting equipment to 2nd headlamp
and adjust 2nd lamp as necessary.
Switch off headlamps.
Remove beamsetter.
4.
5.
M86 5629
2.
3.
Carefully peel back plastic sheet to expose
mechanism.
Release clip and detach solenoid link from latch.
M86 5630
4.
5.
Ensure sill button is fully raised.
Fully extend solenoid actuator then lower 3.5
mm +/- 1.00 mm.
6.
Whilst holding actuator in this position, adjust
length of link, until link pin is aligned with hole in
latch lever.
7.
8.
9.
Connect link and secure with clip.
Secure plastic sheet.
Fit door trim casing.  See  CHASSIS AND
BODY, Repair.
ADJUSTMENT
1
Product Specification
CategoriesLand Rover, Land Rover Defender
Tags
Model Year1999, 2000, 2001, 2002
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 627 pages
Document TypeWorkshop Manual
LanguageEnglish
Product NameDefender
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field