ENGINE
VALVE - RELIEF - OIL PRESSURE
Service repair no - 12.60.56
Remove
COOLER - ENGINE OIL
Service repair no - 12.60.68
Remove
1.
Remove sump gasket. See this Section.
1. Drain cooling system. See COOLING
SYSTEM, Adjustment.
2.
Remove centrifuge assembly. See this
Section.
2.
3.
Remove and discard oil pressure relief valve
plug from oil pump housing.
Remove spring and valve.
3.
4.
Remove clutch housing bolt and release coolant
pipe from rear of engine.
Release clip and coolant hose from oil cooler.
Refit
4.
5.
6.
7.
8.
Clean valve and spring.
Clean valve seating inside oil pump housing.
Lubricate valve and seating.
Fit valve and spring to pump.
Apply Loctite 243 sealant to threads of a new
plug.
5. Disconnect oil pressure switch multiplug.
6. Remove oil filter element using a suitable strap
wrench.
7. Remove 3 bolts, remove oil filter adaptor and
discard gasket.
9.
10.
11.
Fit plug and tighten to 23 Nm ( 17 lbf.ft) .
Fit sump gasket. See this Section.
Check engine oil level, top-up if necessary.
8.
9.
Remove 7 bolts, remove oil cooler and discard
gasket.
Remove oil pressure switch.
REPAIR
29
| Categories | Land Rover, Land Rover Defender |
|---|---|
| Tags | Land Rover |
| Model Year | 1999, 2000, 2001, 2002 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Name | Defender |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)