1999-2002 Land Rover Defender Workshop Manual

12
ENGINE
Refit
STARTER RING GEAR
Service repair no - 12.53.19
Remove.
1.
Clean crankshaft rear oil seal housing mating
face on cylinder block, ensure bolt and dowel
holes are clean and dry. Remove all traces of oil
from oil seal running surface on crankshaft.
1.
Remove flywheel.  See  Repair.
2.
Position seal protector LRT-12-061 over
crankshaft boss. Fit new seal and housing,
remove LRT-12-061.
CAUTION: Oil seal must be fitted dry.
2.
3.
Drill a 3 mm (0.12 in) diameter hole at root of 2
teeth.
Apply a cold chisel to root of teeth, break ring
gear and remove from flywheel.
WARNING: SUITABLE EYE PROTECTION
MUST BE WORN.
Refit
1.
Heat ring gear evenly to 350°C, indicated by
light blue colour.
2.
Locate ring gear on flywheel and press on to
flange.
WARNING: Handle hot ring gear with care.
3.
Fit oil seal housing bolts and using sequence
shown, tighten to 9 Nm (7 lbf.ft) .
Fit sump gasket.  See this Section.
Fit flywheel.  See  Repair.
3.
4.
Allow ring gear to air cool.
Fit flywheel.  See  Repair.
4.
5.
22
OVERHAUL
Product Specification
CategoriesLand Rover, Land Rover Defender
Tags
Model Year1999, 2000, 2001, 2002
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 627 pages
Document TypeWorkshop Manual
LanguageEnglish
Product NameDefender
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field