288
STARTING AND OPERATING
when activation cond itions are not met. The stabilizer/
sway bar shou ld rem ain in on-road mode during norm al
driving cond itions.
To disconnect the stabilizer/ sway bar, shift to either 4HI
or 4LO (refer to “Fou r Wheel Drive Operation” in this
section) and press the stabilizer/ sway bar button to
obtain the off-road position. The amber ind icator light
will flash until the stabilizer/ sway bar has been fully
disconnected .
WARN ING!
Do not discon nect the stab ilizer bar and drive on
hard surfaced road s or at speed s above 18 mph (29
km/h), you may lose control of the veh icle, which
could resu lt in seriou s injury. The fron t stab ilizer bar
enhances veh icle stab ility and is necessary for main -
tain ing control of the veh icle. The system monitors
veh icle speed and will attem pt to recon nect the
stab ilizer bar at speed s over 18 mph (29 km/h). This is
indicated by a flash ing or solid “Sw ay Bar Indicator
Ligh t.” Once veh icle speed is red uced below 14 mph
NOTE: The stabilizer/ sway bar may be torqu e locked
due to left and right suspension height differences. This
cond ition is due to driving surface differences or vehicle
load ing.
In ord er for the stabilizer/ sway bar to
disconnect/ reconnect, the right and left halves of the bar
must be aligned . This alignm ent may requ ire that the
vehicle be driven onto level grou nd or rocked from side
to side.
To retu rn to on-road mode, press the stabilizer/ sway bar
button again.
(22
km/h), the system will once again attem pt to
retu rn to off road mode.
| Categories | Jeep Manuals, Jeep Wrangler Manuals |
|---|---|
| Model Year | 2007 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)