MAINTAINING YOUR VEHICLE
367
Your vehicle has a simple ignition key actu ated test,
which you can use prior to going to the test station. To
check if you r vehicle’s OBD system is read y, you must do
the follow ing:
ignition key or start the engine. This means that you r
vehicle’s OBD system is not read y and you shou ld not
proceed to the I/ M station.
b. The MIL will not flash at all and will rem ain fully
illuminated until you turn off the ignition key or start
the engine. This means that you r vehicle’s OBD system
is read y and you can proceed to the I/ M station.
1.
Insert you r ignition key into the ignition switch.
2.
Turn the ignition to the ON position, but do not crank
or start the engine.
If you crank or start the engine, you will have to start
this test over.
As soon as you turn you r key to the ON position, you
If you r OBD system is not read y, you shou ld see you r
authorized dealer or rep air facility. If you r vehicle was
recently serviced or had a battery failu re or rep lacem ent,
you may need to do nothing more than drive you r
vehicle as you norm ally would in ord er for you r OBD
system to update. A recheck with the above test rou tine
may then ind icate that the system is now read y.
3.
4.
will see you r MIL sym bol come on as part of a norm al
bulb check.
7
5.
Approxim ately 15 second s later, one of two things will
hap pen:
Regard less of whether you r vehicle’s OBD system is
read y or not read y, if the MIL sym bol is illuminated
during norm al vehicle operation, you shou ld have you r
a. The MIL will flash for abou t 10 second s and then
retu rn to being fully illuminated until you turn off the
Product Specification
Categories | Jeep Manuals, Jeep Wrangler Manuals |
---|---|
Model Year | 2007 |
Download File |
|
Document File Type | |
Copyright | Attribution Non-commercial |