Mpi
KNOCK SENSOR
Service repair no - 18.30.18
Remove
IGNITION COILS
Service repair no - 18.20.40 - 1 & 4 Cylinders
Service repair no - 18.20.41 - 2 & 3 Cylinders
Remove
1.
2.
Disconnect multiplug from knock sensor.
Remove knock sensor.
1. Disconnect battery negative lead.
2.
Disconnect 4 h.t. leads from coils.
NOTE: Mark the position of the h.t. leads
to ensure correct refitment.
3.
4.
5.
Disconnect 2 multiplugs from coils.
Disconnect crankshaft sensor multiplug.
Remove screw securing crankshaft sensor
multiplug to coil bracket.
6.
Remove 3 bolts securing coil bracket to bell
housing.
NOTE: Access to the rear bolts is from
under the vehicle.
Refit
7.
Remove coil assembly.
3.
4.
5.
Clean mating face of cylinder block.
Fit knock sensor. Tighten to 15 Nm
Connect multiplug.
Refit
8.
9.
10.
Position coil assembly to bell housing.
Fit 3 bolts and tighten to the correct torque.
Secure crankshaft sensor multiplug to coil
bracket with screw.
11.
12.
13.
Connect crankshaft sensor multiplug.
Connect multiplugs and h.t. leads to coils.
Reconnect battery negative lead.
REPAIR
1
| Categories | Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1998 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)