54
FRONT AXLE AND FINAL DRIVE
Swivel assembly components
Check and adjust preload on bearings
NOTE: Swivel housing oil seal and axle
should not be fitted.
47.
Attach a spring balance to ball joint bore and pull
balance to determine effort required to turn
swivel pin housing.
Resistance, once initial inertia has been
overcome, should be 1.16 to 1.46 kg. Adjust by
removing or adding shims to top swivel pin.
48.
When setting is correct remove top swivel bolts,
apply Loctite 270 or equivalent. Refit to 78 Nm,
and bend over lock tabs.
Apply recommended grease between lips of
swivel oil seal.
Fit oil seal, joint washer and retaining plate with
seven bolts and spring washers to 11 Nm.
Fit tie rod and drag link and secure with new
cotter pins. Tighten to 40 Nm.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Swivel pin housing
Top swivel pin and brake hose bracket
Upper and lower swivel pin bearings
Shim
Retaining plate and washer
Oil seal
Joint washer
Swivel bearing housing
Joint washer
49.
50.
51.
52.
53.
54.
Fit brake disc shield.
10.
11.
12.
Lower swivel pin
Mudshield bracket
Swivel housing inner oil seal
Loosely fit lock stop bolt and nut.
Apply a recommended grease between lips of
swivel housing oil seal.
55.
56.
Secure oil seal with retaining plate and securing
bolts. Tighten to 11 Nm.
Fit track-rod and drag link and secure with new
cotter pins.
57.
58.
Loosely fit lock stop bolt for later adjustment.
Fit brake disc shield.
6
OVERHAUL
| Categories | Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1998 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)