51
REAR AXLE AND FINAL DRIVE
REAR BRAKE DISC NON ABS
Service repair no - 70.10.11.
Remove
REAR BRAKE DISCS ABS
Service repair no - 70.11.11.
Remove
1.
Remove rear hub assembly. See Rear Hub
Assembly
1. Remove rear hub assembly. See Rear Hub
Assembly
2.
3.
Remove disc bolts.
Remove disc from rear hub.
2. Remove five nyloc nuts.
3. Remove sensor ring.
4.
Remove five hub to disc retaining bolts.
Refit
5. Remove disc from hub.
4.
5.
6.
Fit disc to rear hub.
Fit disc bolts. Tighten to 73 Nm.
Check total disc run out, this must not exceed
Refit
6. Fit disc onto hub.
0,15
mm. If necessary reposition disc.
7. Apply loctite 270 and fit hub to disc retaining
bolts. Tighten to 73 Nm.
8.
Using new nyloc nuts fit sensor ring.
9.
Check total disc run out, this must not exceed
0,15
mm. If necessary reposition disc.
10.
Fit hub assembly. See Rear Hub Assembly
7.
Fit rear hub assembly. See Rear Hub
Assembly
Disc reclamation
Check disc thickness. This dimension may be
reduced to a minimum thickness of 12 mm.
Machine equal amounts off each face.
Disc reclamation
Check disc thickness. This dimension may be
reduced to minimum thickness of 12 mm.
Machine equal amounts off each face.
11.
8.
2
REPAIR
| Categories | Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1998 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)