12
ENGINE
FLYWHEEL
Service repair no - 12.53.07
Remove
Refit
1.
2.
Disconnect battery negative lead.
Remove gearbox. See MANUAL GEARBOX,
Repair, R380 Manual Gearbox
8. Locate the flywheel on the crankshaft and
secure with new patched retaining bolts,
progressively tighten to 147 Nm.
3.
4.
Remove clutch. See CLUTCH, Repair, Clutch
Assembly
Fit two long 8mm bolts into the clutch bolt holes,
diametrically opposite, to use as handles when
lifting the flywheel off the crankshaft.
Remove fan cowl
Fit crankshaft pulley retainer LRT-12-080 and
secure with four bolts, to restrain crankshaft
while removing flywheel retaining bolts.
Remove the bolts and lift off flywheel.
5.
6.
7.
9.
Check the flywheel for possible run-out by
mounting a dial test indicator with the stylus in a
loaded condition resting on the flywheel face at a
radius of 114mm from the centre.
10.
Turn the flywheel and check that run-out does
not exceed 0,05 to 0,07mm. Should run-out be
excessive, remove the flywheel and check again
for irregularities on the crankshaft and flywheel
mating faces and the dowel.
11.
Reverse removal procedure. 1 to 6.
NOTE: To prevent excessive flywheel
run-out, ensure that the mating faces of
the flywheel and crankshaft are clean.
14
REPAIR
| Categories | Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1998 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)