To adjust the Zone setting:
If you need to recalibrate the com- Integrated HomeLink® Wireless
Number based upon your current 1. Press and hold the
location on the Zone Map.
Press and hold the button for 6
button for The HomeLink ® Wireless Control
more than 9 seconds. When the System can replace up to three
compass memory is cleared a "C"
will appear in the display.
transmitters with a single built-in
device. This innovative feature will
learn the radio frequency codes of
most current transmitters to operate
devices such as gate operators,
garage door openers, entry door
locks, security systems, even home
lighting. Both standard and rolling
code-equipped transmitters can be
programmed by following the out-
Number will appear on the display. 2. Drive the vehicle in 2 complete cir-
cles at less than 5 mph (8 km/h).
Pressing and holding the
again will cause the numbers to
increment (Note: they will repeat
14, 15, 1, 2, …). Releasing
the button when the desired Zone
Number appears on the display
will set the new Zone.
Within about 5 seconds the com-
pass will start displaying a com-
pass heading again.
Additional HomeLink ® information
can be found at: www.homelink.com
or by calling 1-800-355-3515.
There are some conditions that can
cause changes to the vehicle mag-
nets, such as installing a ski rack or
a CB antenna. Body repair work on
the vehicle can also cause changes
to the vehicle’s magnetic field. In
these situations, the compass will
need to be re-calibrated to quickly
correct these changes.
Retain the original transmitter of the
RF device you are programming for
use in other vehicles as well as for
future HomeLink® programming. It is
also suggested that upon the sale of
HomeLink® buttons be erased for
|Categories||Hyundai Manuals, Hyundai Sonata Manuals|
|Document Type||Owners Manual|
|Product Brand||Hyundai, Sonata|
|Document File Type|
(0 votes, average: 0 out of 5)