1995 Land Rover Discovery Workshop Manual

CRUISE CONTROL
ACTUATOR LINK-SETTING - V8i
Service repair no - 19.75.21
Link - adjust
3.  Remove link from actuator.
4.  Rotate socket joint adjuster as necessary.
NOTE: Setting procedure is carried out at
minimum throttle condition only.
5.  Refit link to actuator and recheck clearance
between link and lever.
6.
With throttle fully open, check a gap of at least
3mm exists between side of link ("A" in
illustration) and side of small spring ("B" in
illustration). Realign link by bending to achieve
correct gap. Recheck clearance at closed
throttle/open throttle. Check link slides smoothly
in groove of throttle lever.
1.
2.
Ensure ignition is switched ’OFF’.
Check clearance between inside edge of
actuator link and recessed diameter of throttle
lever. Clearance should be 0.2 to 2.0 mm.
REPAIR
5
Product Specification
CategoriesLand Rover Discovery, Range Rover
Tags
Model Year1995
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 873 pages
Document TypeWorkshop Manual
LanguageEnglish
Product NameDiscovery
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field