76
CHASSIS AND BODY
ADJUSTMENT-REAR SIDE DOOR LOCK AND
HANDLE
REAR SIDE DOOR GLASS AND REGULATOR
Service repair no - 76.31.45
Remove
Service repair no - 76.37.47
Outside door release handle to lock
1.
Ensure that the window is in the fully closed
position and secure it with adhesive tape over
the top of the door to prevent the glass from
dropping down.
1.
Disconnect the short off-set connecting rod at
the rear of the outer release handle, rotate the
rod clockwise or counter clockwise to shorten or
extend the operating length of the rod as
required.
2. Disconnect battery negative lead.
3. Remove the door trim panel. See rear side
door - trim panel.
NOTE: Door release should occur before
the total handle movement is achieved to
provide a small overthrow movement.
4. Remove the plastic vapour barrier.
5. Where applicable remove the door actuator and
window lift motor. See ELECTRICAL, Repair,
window lift motor - rear. See ELECTRICAL,
Repair, rear side door actuator units.
6.
Remove the four window regulator securing
screws and shakeproof washers from the inner
door panel.
7.
Carefully disengage the lifting arm stud from the
glass lifting channel and remove the window
regulator from the lower opening in the inner
door panel.
8.
9.
Remove the waist rail seal from the top of the
door panel.
Remove the single bolt, spring and plain
washers from inside the door, securing the
bottom of the short glass run channel.
Remove the two bolts, spring and plain washers
from the hinge face of the door.
10.
10
REPAIR
| Categories | Land Rover Discovery, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1995 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Name | Discovery |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)