86
ELECTRICAL
Refit
9. If engine has not been turned while distributor
has been removed, carry out instructions 10. to
17. Alternatively proceed to instruction 18.
10. Fit new ’O’ ring seal to distributor housing.
11. Turn distributor drive until centre line of rotor arm
is 30˚ anti-clockwise from mark made on top
edge of distributor body.
NOTE: If a new distributor is being fitted,
mark body in same relative position as
distributor removed.
12.
Fit distributor in accordance with alignment
markings.
NOTE: It may be necessary to align oil
pump drive shaft to enable distributor
drive shaft to engage in slot.
13.
14.
Fit clamp and bolt. Secure distributor in exact
original position.
Connect vacuum hose to distributor and low
tension lead to coil.
15.
16.
17.
Fit distributor cap.
Reconnect battery.
Using suitable electronic equipment, set ignition
timing. See Adjustment, Ignition timing
If engine has been turned with distributor
removed, carry out instructions 19 to 30.
Set engine-No. 1 piston to static ignition timing
figure See ENGINE TUNING DATA,
Information, Engine 3.9 V8i
18.
19.
20.
Turn distributor drive until rotor arm is
approximately 30˚ anti-clockwise from number
one sparking plug lead position on cap.
8.
Leads for distributor cap should be connected as
illustrated.
21. Fit distributor to engine.
Figures 1 to 8 inclusive indicate plug lead
numbers.
RH-Right hand side of engine, when viewed
22. Check that centre line of rotor arm is now in line
with number one sparking plug lead on cap.
Reposition distributor if necessary.
from rear.
LH-Left hand side of engine, when viewed from
rear.
23. If distributor does not seat correctly in front
cover, oil pump drive is not engaged. Engage by
lightly pressing down distributor while turning
engine.
24.
25.
26.
27.
28.
29.
30.
Fit clamp and bolt, do not tighten.
Set ignition timing statically to 6˚ B.T.D.C.
Connect vacuum hose to distributor.
Fit low tension lead to coil.
Fit distributor cap.
Reconnect battery.
Using suitable electronic equipment set the
ignition timing. See Adjustment, Ignition
timing
6
REPAIR
| Categories | Land Rover Discovery, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1995 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Name | Discovery |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)