SUPPLEMENTARY RESTRAINT SYSTEM
PASSENGER’S AIRBAG MODULE
Service repair no - 76.74.02
WARNING: All the airbag system
components, including the wiring harness,
MUST be renewed after the airbags have
deployed.
Remove
1.
2.
Switch off ignition.
Disconnect battery negative lead and then
positive lead.
6.
7.
Release airbag module from fascia panel.
CAUTION: Do not allow the airbag module
to hang by the airbag harness.
Carefully and without pulling on connector
remove airbag module.
CAUTION: Store the airbag module in
accordance with the storage procedures
described in Description and Operation.
NOTE: If airbag module is to be replaced
the serial number must be recorded in the
vehicle service record.
3.
4.
Open glovebox and disconnect harness
connector from airbag module.
Use special socket and long extension, remove
Refit
2
torx head screws securing front of airbag
module to fascia panel.
Use special socket, remove 2 torx head screws
securing rear of airbag module to fascia panel.
8. Reverse removal procedure.
9. Tighten airbag module securing screws to 8 Nm
(6 lbf ft).
5.
CAUTION: Take care not to cross thread
screws.
10.
Check Supplementary Restraint System using
Testbook.
REPAIR
9
| Categories | Land Rover Discovery, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1995 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Name | Discovery |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)