AIR CONDITIONING
THERMOSTAT
EVAPORATOR/BLOWER MOTOR ASSEMBLY -
REAR
Service repair no - 86.25.50
Remove
Service repair no - 82.26.01
Remove
1.
2.
3.
4.
Remove heater and cooler unit. See Heater
and Cooler Unit
Remove lower cover and evaporator. See
Evaporator and Expansion Valve
Remove 5 clips and screw securing evaporator
top cover.
1. Recover refrigerant from system. See
Adjustment, refrigerant recovery recycling
recharging
WARNING: Wear eye and hand protection
when disconnecting components
Remove evaporator top cover.
containing refrigerant. Plug all exposed
connections immediately.
2.
3.
4.
Remove evaporator to alpine light duct. See
evaporator to alpine light duct
Remove LH rear mud flap. See CHASSIS AND
BODY, Repair, mud flap - rear - lh
Clean area around low and high pressure air
conditioning pipe unions, beneath rear wheel
arch, to prevent any risk of dirt entering the
system.
5.
Remove thermostat sensor from evaporator
matrix.
6.
7.
Remove 2 screws securing sensor unit.
Remove thermostat and insulation.
5.
6.
Loosen and disconnect high and low pressure
air conditioning pipe unions beneath rear wheel
arch.
Refit
8.
Remove and discard ’O’ rings from pipe unions.
Reverse removal procedure.
CAUTION: Use 2 spanners when loosening
or tightening air conditioning pipe unions.
CAUTION: The thermostat insulation must
be installed in the ORIGINAL POSITION in
the evaporator.
CAUTION: Plug exposed connections
immediately.
REPAIR
11
| Categories | Land Rover Discovery, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1995 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Name | Discovery |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)