54
FRONT AXLE AND FINAL DRIVE
Refit
11.
19. Fit original drive shaft shim and secure with a
circlip.
Clean stub axle and drive shaft and fit hub
assembly to axle.
Fit spacing washer.
Fit hub adjusting nut. Tighten to 61 Nm.
Back off adjusting nut 90°. Tighten to 4 Nm.
This will give the required hub end float of
0,010mm
20. To check drive shaft end play mount a dial
gauge using bracket LRT-99-503 and rest pin in
a loaded condition on end of drive shaft.
21. Fit a suitable bolt to threaded end of drive shaft.
Move drive shaft in and out noting dial gauge
reading. End play should be between 0,08 to
0,25 mm.
12.
13.
14.
15.
Fit a new lock washer.
22.
23.
If end play requires adjustment, remove circlip,
measure shim thickness and fit an appropriate
shim to give required end-play.
Remove bolt from drive shaft, fit circlip and dust
cap.
24.
25.
Fit brake caliper. Tighten to 82 Nm.
Bleed brake system. See BRAKES, Repair,
Brake System Bleed
Fit road wheel, remove axle stands and tighten
road wheel nuts to 126 Nm.
16.
17.
Fit locknut. Tighten to 61 Nm.
Tab over lock washer to secure adjusting nut
and locknut.
Fit a new joint washer to driving member and fit
member to hub and secure with five bolts.
Tighten to 65 Nm.
26.
27.
18.
Operate footbrake to locate brake pads before
taking vehicle on road.
4
REPAIR
| Categories | Land Rover Discovery, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1995 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Name | Discovery |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)