STEERING
POWER STEERING BOX
7. Tighten the locknut when all backlash has been
removed.
Service repair no - 57.10.13
8. Repeat the check for backlash. If backlash exists
loosen locknut and repeat adjustment
procedure.
WARNING: Adjustments of steering box
should not be required while in warranty
period. If box is stiff or tight and within
9. Turn steering wheel lock to lock and check no
tightness exists.
warranty, it must be returned to manufacturer. No
attempt must be made to introduce backlash.
10. Ensure front wheels are aligned and in straight
ahead position. See Front Wheel Alignment
11.
Adjust drag link 924 mm between ball joint
centres.
1.
Apply park brake, select ’P’ in automatic
transmission and chock wheels. Support chassis
front on axle stands.
12. Connect drag link. Tighten to 40 Nm.
13. Lower vehicle to ground level and remove
chocks.
14. Road test vehicle. See Fault diagnosis, Road
Test Procedure
2.
3.
4.
Remove engine undertray.
Disconnect drag link from steering drop arm.
Check torque to turn. See Fault diagnosis,
Stiff Steering Checklist
5.
Centralise steering box. See Centralise
Steering Box
NOTE: If steering wheel is not in straight
ahead position when vehicle is travelling
in a straight line, drag link length is
incorrect and is pushing drop arm away from
central position.
NOTE: Only check for no backlash when
steering box is in central position.
NOTE: If steering wheel is not straight, it
should be repositioned. See Repair,
Steering Wheel
The adjustment of the steering box ensures
any preload or end float present on centre is
removed.
Drag link adjust
15. Right hand drive vehicles - if steering wheel is to
right, drag link is too long. If steering wheel is to
left drag link is too short.
Left hand drive vehicles - if steering wheel is to
right, drag link is too short. If steering wheel is to
left drag link is too long.
16. Adjust drag link until steering wheel points
straight ahead when vehicle is travelling in a
straight line.
6.
The adjustment is obtained by rocking the drop
arm about centre whilst an assistant slowly
tightens the steering box adjuster screw.
CENTRALISE STEERING BOX
1.
To centralise the box, insert a suitable peg (hole
size 8.06 mm) into the rear of the drop arm and
into the steering box casing to enable rapid and
accurate setting on centre.
ADJUSTMENT
1
| Categories | Land Rover Discovery, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1995 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Name | Discovery |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)