12
ENGINE
FRONT COVER/TIMING GEAR HOUSING GASKET
Service repair no - 12.65.10
Remove
Refit
8. Fit slave guide studs to locate gasket.
9.
Fit new gasket, over slave studs, to cylinder
block.
10.
Align flats on oil pump with flats on crankshaft.
1.
2.
Remove timing belt and gears. See Camshaft
Drive Belt and Gears
Remove fuel injection pump. See FUEL
SYSTEM, Repair, Fuel Injection Pump and
Timing
Remove engine oil sump. See Oil Sump
Remove oil pick up strainer. See Oil Pick-Up
Strainer
11. Fit front cover to block taking care not to damage
oil seal.
12. Secure with bolts of correct length in locations
where slave studs are not fitted (ST3482).
13. Remove slave studs and fit correct length bolts.
14. Tighten to 25 Nm.
3.
4.
5.
6.
7.
Remove bolts securing timing gear housing to
block.
Withdraw timing gear housing complete with
gasket.
Clean all gasket material from mating faces.
15.
Fit oil pick-up strainer. See Oil Pick-Up
Strainer
16.
17.
Fit oil sump. See Oil Sump
Refit fuel injection pump. See FUEL SYSTEM,
Repair, Fuel Injection Pump and Timing
12
REPAIR
| Categories | Land Rover Discovery, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1995 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Name | Discovery |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)