UNDERSTANDING THE FEATURES OF YOUR VEHICLE
121
4.
(where X is Channel 1, 2, or 3). Release both buttons after
the EVIC display show s “Channel X Trained ”.
The EVIC display will show “Channel X Training”
WARN ING!
Your motorized door or gate will open and close
while you are train ing the Universal Transceiver. Do
not train the tran sceiver if peop le or pets are in the
path of the door or gate. A movin g door or gate can
cause seriou s injury or death to peop le and pets or
damage to objects.
NOTE: If the EVIC display show s “Did Not Train”
rep eat step s 2–4.
3
5. Press and hold the just trained HomeLink button and
observe the EVIC display. If the EVIC display show s
“Channel X Transm it” (where X is Channel 1, 2, or 3),
program ming is complete and you r device shou ld acti-
vate when the HomeLink button is pressed and released .
2.
Position the end of you r hand -held transm itter 1-3
inches (3-8 cm) away from the HomeLink buttons.
NOTE: To program the rem aining two HomeLink but-
tons, begin with ЉProgram mingЉ step two. Do not rep eat
step one.
3.
Simultaneou sly press and hold both the HomeLink
button that you want to train and the hand -held trans-
mitter buttons. Do not release the button s until step 4
has been completed .
NOTE: If you r hand -held transm itter appears to pro-
gram the universal transceiver, but you r garage door
does not operate using the transm itter and you r garage
door opener was manu factu red after 1995, you r garage
door opener may have a multiple security code system
(rolling code system ). Please proceed to step s 6–8 to
NOTE: Some gate operators and garage door openers
may requ ire you to rep lace this Program ming Step 3 with
proced ures noted in the ЉGate Operator/ Canad ian Pro-
gram mingЉ section.
| Categories | Chrysler 300 Manuals, Chrysler Manuals |
|---|---|
| Model Year | 2005 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)