UNDERSTANDING YOUR INSTRUMENT PANEL
209
cluster. To reset the oil change ind icator system (after is in the ON position, before engine start. If the bulb does
perform ing the sched uled maintenance), refer to the not come on when turning the key from OFF to ON, have
follow ing proced ure:
the cond ition checked prom ptly.
1.
Turn the ignition switch to the ON position (Do not Certain cond itions such as a loose or missing gas cap,
start the engine).
poor quality fuel, etc. may illuminate the light after
engine start. The vehicle shou ld be serviced if the light
stays on throu gh several typ ical driving styles. In most
situ ations, the vehicle will drive norm ally and will not
2.
Fully depress the accelerator pedal slow ly three
times within 10 second s.
4
3.
Turn the ignition switch to the OFF/ LOCK position. requ ire tow ing.
NOTE: If the ind icator message illuminates when you When the engine is running, the MIL may flash to alert
start the vehicle, the oil change ind icator system did not seriou s cond itions that could lead to immediate loss of
reset. If necessary rep eat this proced ure.
power or severe catalytic converter damage. The vehicle
shou ld be serviced as soon as possible if this occurs.
25.
Malfunct ion Indica tor Light (MIL)
The Malfu nction Ind icator Light (MIL) is a part of
an Onboard Diagnostic System called OBD II that
monitors engine and autom atic transm ission con-
trol system s. The light will illuminate when the ignition
| Categories | Jeep Manuals, Jeep Wrangler Manuals |
|---|---|
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)