STARTING AND OPERATING
295
REAR AXLE LOCK (FOUR-WHEEL DRIVE
NON-RUBICON MODELS) — IF EQUIPPED
The REAR AXLE LOCK switch is located on the lower
switch bank (below the climate controls).
NOTE: The ind icator lights will flash until the axle is
fully locked or unlocked .
The rear axle lock will disengage if the vehicle is taken
out of 4L (Low) range, or the ignition switch is turned to
This featu re will only activate when the follow ing con- the LOCK position.
ditions are met:
ELECTRONIC SWAY BAR DISCONNECT — IF
EQUIPPED
Your vehicle may be equ ipped with an electronic discon-
necting stabilizer/ sway bar. This system allow s greater
front suspension travel in off-road situ ations.
•
•
To activate the system , press the REAR AXLE LOCK
switch down to lock the rear axle (the “Rear Axle Lock
Ind icator Light” will illuminate); press the switch up to
unlock the rear axle.
Key in ignition, vehicle in 4L (Low) range.
Vehicle speed shou ld be 10 mph (16 km/ h) or less.
5
| Categories | Jeep Manuals, Jeep Wrangler Manuals |
|---|---|
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)