ENGINE - V8
Reassembly
1.
Ensure both seal location and running surface
on crankshaft are clean. Ensure that bolt holes
in crankshaft are clean and dry.
Seal - crankshaft - rear - manual models
$% 12.21.20.01
Disassembly
1.
2.
Restrain flywheel.
Working in sequence, loosen and remove 6
bolts securing clutch cover to flywheel.
Remove clutch cover.
2.
3.
Lubricate replacement oil seal with engine oil.
Lubricate seal guide LRT-12-095 with engine
oil and position guide to crankshaft.
Fit new seal squarely onto crankshaft and
remove guide LRT-12-095.
Fit seal into location using tools LRT-12-091
and LRT-99-003.
All engines: Ensure bolt holes in crankshaft
are clean and dry.
3.
4.
5.
Remove clutch plate.
4.
5.
6.
Remove CKP sensor.
+
ENGINE MANAGEMENT SYSTEM -
V8, REPAIRS, Sensor - crankshaft position
(CKP).
7.
8.
All engines: Clean all components.
All engines: Check that drive plate is free from
cracks and distortion.
9.
Early engines: Fit hub, starter ring gear and
spacer to crankshaft, tighten Allen bolts to 78
Nm (58 lbf.ft).
10.
11.
12.
13.
Early engines: Fit drive plate and clamp ring,
tighten bolts to 45 Nm (35 lbf.ft).
Later engines: Fit starter ring gear, fit Allen
bolts and tighten to 85 Nm (63 lbf.ft).
Later engines: Fit drive plate and clamp ring,
fit bolts and tighten to 45 Nm (33 lbf.ft).
Fit CKP sensor.
+
ENGINE MANAGEMENT SYSTEM -
V8, REPAIRS, Sensor - crankshaft position
(CKP).
6.
7.
Remove 6 bolts securing flywheel.
Remove flywheel.
12-2-50
OVERHAUL
| Categories | Land Rover Defender, Land Rover Discovery II, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1999 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Name | Discovery Series II |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)