FRONT SUSPENSION
Refit
1.
Ensure valve block and pipe connections are
clean.
2.
3.
Install clamping plate and collets on rear pipes.
Position pipe assembly to vehicle and connect
pipes and clamping plate to valve block. To
avoid damage to seals, keep pipes square
to valve block. Fit and tighten nuts securing
clamping plate to valve block to 21 Nm (15
lbf.ft).
CAUTION: Ensure pipes are installed in
their correct ports or serious system
damage will occur.
7.
Remove 2 cap nuts securing pipes to ACE rear
actuator. Disconnect pipes, remove and
discard sealing washers.
4.
5.
Fit bolts securing rear pipe clips to chassis and
tighten to 6 Nm (4.4 lbf.ft).
Connect pipes to actuator with cap nuts and
new sealing washers. Tighten cap nuts to 29
Nm (21 lbf.ft). Ensure pipes are not under
tension or kinked.
CAUTION: Always fit plugs to open
connections to prevent contamination.
6.
Ensure washer is in place on lower ball joint of
each anti-roll bar link, then connect lower ball
joints to axle and tighten nuts to 100 Nm (74
lbf.ft).
7.
8.
Renew ACE high pressure filter.
FRONT SUSPENSION, REPAIRS,
Filter - high pressure - ACE.
+
Bleed ACE hydraulic system.
+
FRONT SUSPENSION,
ADJUSTMENTS, ACE hydraulic system
bleeding.
9.
Lower vehicle.
8.
Remove 2 nuts securing rear pipe clamping
plate. Release clamping plate and pipes from
valve block.
CAUTION: Always fit plugs to open
connections to prevent contamination.
9.
10.
Remove pipe assembly.
Remove collets and clamping plate from rear
pipes.
60-60
REPAIRS
| Categories | Land Rover Defender, Land Rover Discovery II, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1999 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Name | Discovery Series II |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)