REAR SUSPENSION
Sensor - height - SLS
Compressor unit - air - SLS
$% 64.36.01
$% 64.50.10
WARNING: Ensure the air suspension system is
made safe before commencing work. Otherwise
the chassis may lower onto the bump stops
during repair.
WARNING: Ensure the air suspension system is
made safe before commencing work. Otherwise
the chassis may lower onto the bump stops
during repair.
Remove
Remove
1.
Raise rear of vehicle.
1. Using TestBook, depressurise SLS air system.
After depressurisation, approximately 1 bar
WARNING: Do not work on or under a
vehicle supported only by a jack. Always
support the vehicle on safety stands.
(15 lbf.in2
system.
) air pressure remains in the
2.
3.
Release 2 fasteners and remove air
compressor unit cover.
Remove 2 bolts securing air compressor unit to
chassis. Release unit and lower onto blocks to
support the weight.
2.
3.
Disconnect height sensor multiplug.
Remove bolt securing height sensor link to
radius arm.
4.
Remove 2 bolts securing height sensor to
chassis and remove height sensor.
Refit
1.
4.
Noting their fitted position, disconnect pipes
from air valves.
Position height sensor to chassis and tighten
bolts to 6 Nm (4.4 lbf.ft).
2.
Position height sensor link to radius arm and
tighten bolt to 25 Nm (18 lbf.ft).
CAUTION: Always fit plugs to open
connections to prevent contamination.
3.
4.
5.
Connect height sensor multiplug.
Remove stand(s) and lower vehicle.
Use TestBook to calibrate height sensor.
REPAIRS
64-35
| Categories | Land Rover Defender, Land Rover Discovery II, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1999 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Name | Discovery Series II |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)