TRANSFER BOX - LT230SE
ADJUSTMENTS
Cable - selector - differential lock - adjust
Cable - high/low selector
$% 41.20.11
$% 41.20.46
Check
Adjust
1.
Check operation of differential lock selection
and adjust cable if required.
1. Raise vehicle on ramp.
Adjust
1.
Remove front propeller shaft.
PROPELLER SHAFTS, REPAIRS,
+
Propeller shaft - front.
2.
3.
4.
Loosen locknuts securing outer cable to
abutment bracket.
Move differential lock selector lever to non
differential lock position.
Move differential lever on transfer gearbox fully
forward to rotate selector shaft anti-clockwise
into the non differential lock detent position.
2.
Using a suitable crows foot spanner, loosen
lock nuts securing outer cable to abutment
bracket.
Select high range by moving lever on transfer
gearbox fully forward.
Insert tool LRT-41-016 through hole in selector
lever and housing. This ensures selector
lever is in the high range position.
CAUTION: Should the lever move past the
detent, allow it to move back into the non
differential lock detent position before
adjusting the cable.
3.
4.
5.
6.
Without moving levers, simultaneously tighten
differential lock outer cable locknuts either side
of the abutment bracket to 30 Nm (22 lbf.ft).
Fit front propeller shaft.
5. Check that tool LRT-41-016 is a sliding fit in
selector lever and housing.
6. Simultaneously tighten high/low selector cable
lock nuts either side of abutment bracket to 30
Nm (22 lbf.ft) .
+
PROPELLER SHAFTS, REPAIRS,
Propeller shaft - front.
7.
Remove tool LRT-41-016 from gear selector
lever and housing.
8.
Lower vehicle on ramp.
ADJUSTMENTS
41-21
Product Specification
Categories | Land Rover Defender, Land Rover Discovery II, Range Rover |
---|---|
Tags | Land Rover |
Model Year | 1999 |
Download File |
|
Document Type | Workshop Manual |
Language | English |
Product Name | Discovery Series II |
Product Brand | Land Rover |
Document File Type | |
Publisher | landrover.com |
Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
Copyright | Attribution Non-commercial |