REAR SUSPENSION
Refit
Air spring - SLS
$% 64.21.01
Remove
1. Clean mating faces of air spring, axle and
chassis.
CAUTION: Check air bag for signs of
damage. If air bag is damaged, air spring
must be replaced.
1.
Using TestBook, depressurise SLS air system.
After depressurisation, approximately 1 bar
2. Fit pipe connector to air spring.
3. Locate air spring on axle and rotate 90° to fully
engage bayonet fitting.
(15 lbf.in2
system.
) air pressure remains in the
2.
Raise rear of vehicle and support under
chassis.
4. Connect pipe to top of air spring.
5. Engage top locating pins of air spring in chassis
and secure with clips.
WARNING: Do not work on or under a
vehicle supported only by a jack. Always
support the vehicle on safety stands.
6. Repressurise SLS air system using TestBook.
WARNING: Eye protection must be worn
during the repressurisation procedure.
3.
Remove road wheel.
7.
8.
Fit road wheel and tighten nuts to 140 Nm (103
lbf.ft).
Remove stand(s) and lower vehicle.
4.
5.
Remove 2 clips securing air spring to chassis.
Collapse air spring and disconnect pipe from
top of air spring.
CAUTION: Always fit plugs to open
connections to prevent contamination.
6.
7.
Rotate air spring, to unlock from axle and
remove from vehicle.
Remove connector from pipe.
64-30
REPAIRS
| Categories | Land Rover Defender, Land Rover Discovery II, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1999 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Name | Discovery Series II |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)