RESTRAINT SYSTEMS
5.
Remove air bag module.
Airbag module - drivers
WARNING: Store the airbag module with the
deployment side uppermost. If it is stored
deployment side down, accidental
$% 76.74.01
deployment will propel the airbag module
with enough force to cause serious injury.
WARNING: It is imperative that before any work
is undertaken on the SRS system the appropriate
information is read thoroughly.
WARNING: Store the airbag module or seat
belt pre-tensioner in a designated storage
area. If there is no designated storage area
available, store in the locked luggage
compartment/loadspace of the vehicle and
inform the workshop supervisor.
WARNING: Always disconnect both battery leads
before beginning work on the SRS system.
Disconnect the negative battery lead first. Never
reverse connect the battery.
Remove
Refit
1.
Remove the key from the starter switch.
Disconnect both battery leads, negative lead
first. Wait ten minutes before starting work.
NOTE: If the airbag module is to be replaced,
the bar code of the new module must be
recorded.
1.
2.
Position air bag module and connect multiplug.
Fit air bag module to steering wheel and tighten
Torx bolts to 9 Nm (7 lbf.ft).
3.
Connect battery leads, earth lead last.
2.
3.
Remove 2 Torx bolts securing air bag module
to steering wheel.
Release air bag module from steering wheel.
CAUTION: Do not allow the air bag module
to hang by the air bag harness.
4.
Disconnect multiplug from air bag module.
75-22
REPAIRS
| Categories | Land Rover Defender, Land Rover Discovery II, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1999 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Name | Discovery Series II |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)