ENGINE MANAGEMENT SYSTEM - V8
Conditions
The CAN system is used by the EAT ECU and the ECM for transmission of the following information:
l
l
l
l
l
l
l
l
l
l
l
Gearshift torque control information.
EAT OBD information.
MIL request.
Vehicle speed signal.
Engine temperature.
Engine torque and speed.
Gear selected.
Gear change information.
Altitude adaptation factor
Air intake temperature
Throttle angle / pedal position
Function
The CAN system uses a twisted pair of wires to form the 'data bus' to minimise electrical interference. This method of
serial interface is very reliable and very fast. The information messages are structured so that each of the receivers
(ECM or EAT ECU) is able to interpret and react to the messages sent.
The CAN 'data bus' is directly connected between pin 36 of connector C0637 of the ECM and pin 16 of connector
C0193 at the EAT ECU, and pin 37 of connector C0637 of the ECM and pin 44 of connector C0193 at the EAT ECU.
The CAN system can fail in the following ways:
l
l
CAN data bus wiring open circuit.
CAN data bus wiring short circuit.
In the event of a CAN data bus failure any of the following symptoms may be observed:
l
l
l
l
MIL illuminated after 2 drive cycles (NAS only).
EAT defaults to 3rd gear only.
Harsh gearshifts.
'Sport' and 'manual' lights flash alternately.
Should a malfunction of the component occur the following fault codes may be evident and can be retrieved by
TestBook.
P Code
P0600
P1776
J2012 Description
Land Rover Description
Serial communication link malfunction
CAN time out
EAT torque interface error
Transmission control system torque interface
malfunction
Drive cycles
The following are the TestBook drive cycles:
⇒
Drive cycle A:
1
2
3
4
Switch on the ignition for 30 seconds.
Ensure engine coolant temperature is less than 60°C (140°F).
Start the engine and allow to idle for 2 minutes.
Connect TestBook and check for fault codes.
⇒
Drive cycle B:
1
2
3
4
5
6
7
8
Switch ignition on for 30 seconds.
Ensure engine coolant temperature is less than 60°C (140°F).
Start the engine and allow to idle for 2 minutes.
Perform 2 light accelerations (0 to 35 mph (0 to 60 km/h) with light pedal pressure).
Perform 2 medium accelerations (0 to 45 mph (0 to 70 km/h) with moderate pedal pressure).
Perform 2 hard accelerations (0 to 55 mph (0 to 90 km/h) with heavy pedal pressure).
Allow engine to idle for 2 minutes.
Connect TestBook and with the engine still running, check for fault codes.
18-2-58
DESCRIPTION AND OPERATION
| Categories | Land Rover Defender, Land Rover Discovery II, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1999 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Name | Discovery Series II |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)