FRONT SUSPENSION
Refit
Filter - high pressure - ACE
1. Ensure new filter has 'O' ring fitted, then fit filter
to valve block.
2.
Fit new 'O' ring to filter cap. Fit cap and tighten
to 35 Nm (26 lbf.ft).
$% 60.60.21
3.
Lower vehicle.
CAUTION: The ACE hydraulic system is
extremely sensitive to the ingress of dirt or
debris. The smallest amount could render the
system unserviceable. It is imperative that the
following precautions are taken.
4. Check fluid level in ACE/PAS reservoir.
FRONT SUSPENSION,
ADJUSTMENTS, Fluid level check - ACE
system.
+
5. Start and run engine for 2 minutes, then re-
check fluid level in ACE/PAS reservoir.
l
l
l
ACE components are thoroughly cleaned
externally before work commences;
all opened pipe and module ports are
capped immediately;
all fluid is stored in and administered
through clean containers.
+
FRONT SUSPENSION,
ADJUSTMENTS, Fluid level check - ACE
system.
Remove
1.
2.
Raise vehicle on a ramp.
Position container to collect fluid spillage.
3.
4.
Remove filter cap and discard 'O' ring.
Fit M6 bolt into base of filter and pull on bolt to
remove filter from valve block. Do not turn
filter in valve block.
CAUTION: Always fit plugs to open
connections to prevent contamination.
REPAIRS
60-47
| Categories | Land Rover Defender, Land Rover Discovery II, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1999 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Name | Discovery Series II |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)