1995 Land Rover Range Rover Classic Workshop Manual

V8i
ROCKER SHAFT RENEW
Service repair no - 12.29.29
HYDRAULIC TAPPETS RENEW
Service repair no - 12.29.57
1.
2.
Remove rocker covers as required.  See
Rocker Cover - Right Hand - Renew  or  See
Rocker Cover - Left Hand - Renew
Loosen four rocker shaft fixings.
1.  Remove rocker shafts.  See  Rocker Shaft
Renew
2.  Remove intake manifold.  See FUEL SYSTEM,
Repair,  Intake Manifold
3.
Remove push rods, retain in removal sequence.
3.
Remove rocker shaft assembly.
4.
Remove hydraulic tappets
NOTE: Each rocker shaft is notched at
ONE end. Notch must be uppermost and
towards front of engine on right hand side,
5.  Fit tappets, push rods and rocker assemblies.
See V8i Overhaul Manual.
6.  Fit inlet manifold.
towards rear on left hand side.
7.  Reverse removal procedure.
4.
5.
Clean rocker pedestal locations on cylinder
head.
Fit rocker shaft assembly, locating push rods to
rockers.
6.
7.
Tighten rocker shaft fixings to 38 Nm.
Fit rocker covers.
REPAIR
7
Product Specification
CategoriesLand Rover, Range Rover
Tags
Model Year1995
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 767 pages
Document TypeOwners Manual
LanguageEnglish
Product NameRange Rover Classic
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field