ABS
RESERVOIR (INCLUDE SEALS)
Service repair no - 70.65.22
Remove
HYDRAULIC POWER UNIT
Service repair no - 70.65.20
Remove
1.
2.
Disconnect battery negative lead.
Depressurise system. See Depressurise
System
1. Disconnect battery negative lead.
2. Depressurise system. See Depressurise
System
3.
4.
Disconnect low fluid warning plug.
Remove reservoir cap. Remove hose from
pump, plugging exposed apertures.
Remove securing bolt, adjacent to low pressure
hose.
3. Disconect braided hose to accumulator.
4. Disconnect low pressure hose to reservoir,
clamp hose to prevent fluid loss and ingress of
debris.
5.
6.
Ease reservoir from booster unit.
5.
6.
Disconnect pressure switch plug.
Disconnect power unit connector.
7.
Remove two seals from top of booster unit.
Avoid damage to seals which could result in
rubber particles entering system. Plug booster
unit apertures
7. Working below unit remove four nuts and plain
washers.
8. Remove hydraulic power unit complete with
mountings. Note position of earth strap, if fitted,
when removing mountings.
Refit
8.
Refit
Lubricate and fit new seals. Refit reservoir.
Tighten securing bolt to 10 Nm.
9. Reverse removal procedure. Fit new sealing
9.
Bleed pump. Check/top up fluid level.
washers on high pressure hose.
10.
Bleed system. See Brake System Bleed
(ABS)
REPAIR
5
| Categories | Land Rover, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1995 |
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Name | Range Rover Classic |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)