44
AUTOMATIC GEARBOX
13.
14.
Fit control unit after cleaning face with a lint free
rag. Ensure selector shaft locates into gear shift
fork. Fit thirteen bolts loosely.
Place selector linkage setting gauge LST109 in
position, gently press control unit in direction
shown. Tighten all thirteen bolts to 8Nm.
15.
Remove setting gauge. Fit oil screen, tighten
fixings to 8Nm.
16.
17.
18.
Refit sump with new gasket.
Refit six retaining plates tighten screws to 8Nm.
Reconnect oil filler tube. Tighten to 70Nm. Fit
sump plug with new seal. Tighten to 10Nm.
Fit chassis cross member
19.
20.
21.
22.
Fit front exhaust assembly
Reconnect battery negative lead.
Add correct quantity and grade oil to gearbox.
See LUBRICANTS, FLUIDS AND
CAPACITIES, Information, Recommended
Lubricants and Fluids
10.
Using kickdown cable remover LST112, remove
cable and its housing from casing and discard.
Refit
11.
23.
Connect kickdown cable to engine.
Fit new cable and new ’O’ ring into casing.
Adjust
24.
Adjust cable sheath to achieve a crimp gap of
0.25 to 1.25 mm.
25.
26.
Hold cable sheath while tightening locknuts.
Ensuring vehicle is on level ground with park
brake applied. Check oil level with engine at idle
with neutral selected, after selecting each gear.
12.
Spring load cam by turning once before fitting.
Fit nipple into cam seat.
6
REPAIR
| Categories | Land Rover, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1995 |
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Name | Range Rover Classic |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)