CHASSIS AND BODY
SUNROOF PANEL SEALS
Service repair no - 76.82.55
Remove
SUNROOF ASSEMBLY
Service repair no - 76.82.71
Including roof panel. Slide mechanism. Wind
deflector. Motor mounting bracket. Guide tubes.
1.
2.
Position sunroof in tilt position and Disconnect
battery negative lead.
Unclip sunroof headliner from roof panel front
and slide headliner back.
Remove
NOTE: Remove vehicle headlining ONLY if
removing motor mounting bracket and
guide tubes. See Headlining
3.
Remove three roof panel screws from each side
and remove panel.
4.
Remove both seals from roof panel.
1.
Partially open sunroof and unclip sunroof
headliner from roof panel front. Slide sunroof
headliner back.
Refit
5.
Fit front seal to front edge of panel. Ensure there
is an equal length of seal each side of centre
point.
Butt rear seal against front seal fit tight around
panel edge. Trim excess seal to produce a close
joint with front seal.
2. Move sunroof to tilt position. Disconnect battery
negative lead.
3. Remove three roof panel screws from each side
and remove panel.
6.
7.
4. Remove motor screws and withdraw motor.
Refit sunroof panel.
5.
6.
Remove guide rail screws, seven each side.
Remove pivot bracket and remove front guide
rail.
7.
Remove slide and tilt mechanism with flexible
drive cable from both sides. Only disassemble if
replacement parts are required.
REPAIR
49
| Categories | Land Rover, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1995 |
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Name | Range Rover Classic |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)