ABS
GENERAL SERVICE INFORMATION
DEPRESSURISE SYSTEM
NOTE: ABS components ARE NOT
serviceable. Replace components found to
be faulty.
WARNING: Before bleeding the system or
working on any component in the brake
system the following procedure MUST be
carried out to depressurise the accumulator.
Brake fluid precautions
1.
Switch off ignition.
WARNING: Do not allow brake fluid to
come into contact with eyes or skin.
2. Operate the brake pedal 30 times. Pedal travel
will increase slightly and reduced resistance will
be felt as pressure decreases.
CAUTION: Brake fluid can damage
paintwork, if spilled wash off immediately
with plenty of clean water.
3. Wait for 60 seconds, press the brake pedal four
more times. This procedure will ensure that all
pressure is evacuated from the system.
CAUTION: Use only correct brake fluid. If
an assembly fluid is required use ONLY
brake fluid. Do NOT use mineral oil, i.e.
engine oil etc.
FLUID LEVEL CHECK / TOP UP
1.
2.
Park vehicle on level ground.
Turn ignition ON, to activate hydraulic pump. If
pump does not activate depress brake pedal
several times until pump operates.
When pump stops, check level is between ’MIN’
and ’MAX’ marks.
If level is below ’MIN’ mark top up fluid level to
’MAX’ mark on reservoir, using correct fluid. See
LUBRICANTS, FLUIDS AND CAPACITIES,
Information, Recommended Lubricants and
Fluids
3.
4.
WARNING: Clean reservoir body and filler
cap before removing cap. Use only fluid
from a sealed container.
DO NOT OVER FILL RESERVOIR
REPAIR
1
| Categories | Land Rover, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1995 |
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Name | Range Rover Classic |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)