AIR SUSPENSION
BUMP STOP
Service repair no - 60.30.10
CAUTION: Air suspension system uses
’progressive’ bump stops, which must not
be interchanged with those used on coil
spring suspension.
Remove
6.
7.
Remove four retaining clips from upper and
lower fixing.
Lower axle for access to air pipe connection at
top of air spring.
8.
Clean connection with a stiff brush and soapy
water. Peel back rubber boot.
9.
Disconnect air pipe. See Disconnect/Connect
Air Pipe , seal all ends.
10.
Refit
11.
12.
Remove air spring assembly.
1.
2. Remove bump stop assembly.
Remove 2 locknuts and bolts with flat washers.
Locate air spring assembly onto lower fixing.
Ensure air pipe connection points towards rear.
Connect air pipe to air spring assembly, fitting
rubber boot. See Disconnect/Connect Air
Pipe
Refit
3. Position fixing bolts and flat washers in chassis
13.
Raise axle to locate air spring assembly into
upper fixing, if required.
Fit four new retaining clips to fixing points.
Reverse removal instructions 1 to 5.
Leak test air spring and connector. See
Adjustment, Leak Test Procedure
bracket.
4. Fit bump stop.
5. Tighten fixings.
14.
15.
16.
REPAIR
7
| Categories | Land Rover, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1995 |
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Name | Range Rover Classic |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)