AIR SUSPENSION
COMPRESSOR INLET FILTER
Service repair no - 60.50.12
AIR SUPPLY UNIT
Service repair no - 60.50.23
Change the inlet filter every 40,000 Kms (24,000
miles) - USA 30,000 miles.
Mounted on the chassis this unit contains the
compressor, air drier and valve block. The unit must
be removed before removing these components.
NOTE: Compressor inlet filter is situated
adjacent to the fuel filler flap. Access is
gained by removing the closure plate
WARNING: System is pressurised up to 10
bar. Dirt or grease must not enter the
situated in the right hand side of load space.
system. Wear hand,ear and eye safety
standard protection when servicing system.
Remove
Remove
1.
Remove sub woofer, (if fitted). See
ELECTRICAL, Repair, Subwoofer Box
1. Depressurise system. See Adjustment,
Depressurise System
2.
Disconnect battery negative lead.
3.
4.
5.
Remove air supply unit side cover plate.
Disconnect multiplug.
Disconnect compressor inlet pipe, seal all
exposed ends.
Support air supply unit. Remove four mounting
bolts.
2.
3.
4.
Remove eight screws. Remove closure panel.
Remove inlet filter from mounting bracket.
Remove filter from pipe.
6.
Refit
CAUTION: DO NOT allow unit to hang on
pipes or electrical leads.
5.
6.
Fit new filter.
Reverse removal procedure.
7.
Remove air supply assembly top cover plate.
REPAIR
9
| Categories | Land Rover, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1995 |
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Name | Range Rover Classic |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)