ZF
GOVERNOR HOUSING
Service repair no - 44.22.01
Remove
Refit
10. Fit new governor housing complete to governor
hub and parking wheel. Tighten to 10 Nm.
11. Push governor assembly with parking wheel
onto output shaft until fully seated.
1.
Remove transfer box. See TRANSFER
GEARBOX, Repair, Borg Warner Transfer
Gearbox
NOTE: Apply petroleum jelly to ’O’ ring.
Ensure seal rings are snapped together
and seated.
2.
3.
4.
Remove transfer gear selector housing.
Loosen nine bolts holding extension housing.
Remove extension housing ensuring that seal is
not damaged, discard gasket.
Remove extension shaft and retaining bolt with
’O’ ring. If Tdi vehicle, remove spacer.
Remove governor assembly with parking wheel.
Remove two screws holding governor housing.
Remove governor housing complete and
discard.
12. Fit extension shaft, with spacer if Tdi, apply
Loctite 270 to retaining bolt. Using a new ’O’
ring. Tighten to 42 Nm.
13. Fit new gasket to rear of gearbox. Fit extension
housing, avoid damage to seal.
14. Tighten nine extension housing nine bolts to 23
Nm.
15. Fit transfer gear selector housing.
16. Tighten three bolts to 25Nm.
17. Refit transfer box.
5.
6.
7.
8.
9.
Inspect governor hub and parking wheel for
damage.
REPAIR
13
| Categories | Land Rover, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1995 |
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Name | Range Rover Classic |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)