BORG WARNER
REAR OUTPUT SHAFT OIL SEAL
Service tool: 18G1422
FRONT OUTPUT SHAFT OIL SEAL
Service tool: 18G1422
1.
Disconnect rear propeller shaft from output drive
flange and tie shaft to one side.
Apply parkbrake and release drive flange nut.
Release parkbrake and remove brake drum
secured with two screws.
1. Disconnect front propeller shaft from flange.
2. Apply parkbrake and release drive flange nut.
3. Remove output shaft nut, steel washer, rubber
seal and withdraw flange.
2.
3.
4. Prise out oil seal.
4.
5.
6.
Remove output shaft nut, steel washer, rubber
seal and withdraw flange.
Tap dust cover from housing and remove oil
seal.
5. Lubricate and fit new seal using service tool
18G1422. Fit spring side of seal abuting circlip.
6. Examine flange if surface is corroded or worn by
previous seal discard flange.
7. Lubricate seal running surface of flange.
8. Fit flange. Tighten to 224 Nm
Lubricate and fit new seal using service tool
18G1422.
circlip.
Fit so spring side of seal abuting
9. Refit propeller shaft. Tighten to 46Nm
7.
8.
Fit dust cover.
If necessary release circlip from drive flange to
allow new bolts to be installed.
9.
10.
11.
Examine flange, if surface is corroded or a
groove worn by previous seal discard flange.
Lubricate running surface and fit flange. Do not
tighten nut.
Fit brake drum and secure with two screws.
Apply parkbrake and tighten drive flange nut to
224
Nm
12.
Fit propeller shaft. Tighten to 46Nm
REPAIR
1
| Categories | Land Rover, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1995 |
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Name | Range Rover Classic |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)