V8i
WATER PUMP
Service repair no - 26.50.01
Remove
WARNING: Disconnect battery negative
terminal to prevent engine being started
before removing or adjusting drive belts.
1.
2.
Drain engine cooling system. See Adjustment,
Coolant
Remove fan blades and pulley. See Viscous
Coupling, Fan Blades, Pulley and Fan Cowl
Disconnect inlet hose from water pump.
Remove water pump bolts.
3.
4.
5.
Remove water pump and joint washer.
Test
6.
Note rating of thermostat is 88˚C. Place
thermostat in a container half full of water. Heat
water, observe temperature at which thermostat
opens. Thermostat is satisfactory if it opens
between 85˚C and 89˚C.
Refit
7.
Insert thermostat with jiggle pin/vent hole
uppermost (12 o’clock position).
Fit the outlet elbow and new joint washer.
Tighten to 28 Nm.
8.
9.
10.
Reverse removal procedure. 1 to 3.
Check for coolant leaks around all connections
and joint faces.
Refit
6.
Lightly grease new joint washer, position on
timing cover.
7.
Clean threads of all long bolts and coat with
Loctite 572 thread lubricant-sealant.
Locate water pump in position. Tighten
remaining water pump housing bolts evenly to
8.
28
Nm.
9.
10.
Reverse removal procedure. 1 to 3.
Check for coolant leaks around all hose
connections and joint faces.
REPAIR
3
| Categories | Land Rover, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1995 |
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Name | Range Rover Classic |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)