SUPPLEMENTARY RESTRAINT SYSTEM
CRASH SENSOR
Service repair no - 76.74.04
Remove
1.
2.
Disconnect battery negative lead.
LH sensor only:Slacken power steering
reservoir clamp and lift reservoir to provide
access.
Diesel model only:Remove jack and mounting
bracket.
6.
7.
Release airbag module from fascia panel.
CAUTION: Do not allow the airbag module
to hang by the airbag harness.
Carefully and without pullling on connector
remove airbag module.
CAUTION: Store the airbag module in
accordance with the storage procedures
outlined in Description and Operation.
NOTE: If airbag module is to be replaced
the serial number must be recorded in the
vehicle service record.
3. Disconnect multiplug from sensor
CAUTION: Ensure airbag harness
connector seal and anti-backout DO NOT
come adrift when disconnecting sensor.
Refit
8.
9.
Reverse removal procedure.
Tighten airbag module securing screws to 8 Nm.
4. Use special socket, remove 2 screws securing
crash sensor to body.
5.
Remove crash sensor.
CAUTION: Take care not to cross thread
screws.
Refit
10.
Check Supplementary Restraint System using
6. Reverse removal procedure.
Testbook.
7. Tighten crash sensor securing screws to 10Nm.
Ensure multiplug is fully engaged on sensor and
retained by its latch.
8.
Check Supplementary Restraint System using
Testbook.
REPAIR
7
| Categories | Land Rover, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1995 |
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Name | Range Rover Classic |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)