70
BRAKES
Refit
32.
SERVO ASSEMBLY
Service repair no - 70.50.01
Remove
Fit master cylinder to servo. Secure in position
with two nuts, plain and spring washers. Tighten
to 26 Nm.
33.
34.
Fit brake pipes to master cylinder. Tighten to
10Nm.
Top-up master cylinder with correct grade of
brake fluid. See LUBRICANTS, FLUIDS AND
CAPACITIES, Information, Recommended
Lubricants and Fluids
NOTE: Other than replacing filter,
non-return valve and grommet, the servo
is not a serviceable component, in event of
failure or damage fit a new unit.
35.
Bleed system. See Brake System Bleed (Non
ABS)
1. Disconnect battery negative lead.
2. Disconnect electrical plug to low fluid level
switch.
WARNING: Do not use brake fluid
previously drained or bled from system.
Carefully dispose of unwanted fluid, if
stored in a sealed container, ensure that container
is marked USED BRAKE FLUID.
3. Thoroughly clean immediate area around all
master cylinder outlet ports. Remove each brake
pipe, sealing each pipe and outlet port with
suitable plugs to prevent ingress of foreign
matter.
4.
Disconnect vacuum supply hose to servo.
36.
Fit cap, reconnect electrical lead to fluid level
switch. Reconnect battery negative lead.
5. Remove lower dash panel to gain access to
servo push rod.
6.
7.
Remove clevis pin securing servo push rod to
brake pedal.
Remove 2 nuts and plain washers securing
servo.
8
REPAIR
| Categories | Land Rover, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1995 |
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Name | Range Rover Classic |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)