ABS
SENSORS - REAR
Refit
9.
Service repair no - 70.65.31
8. Fit new sensor bush.
Lightly grease new sensor using silicone grease.
See LUBRICANTS, FLUIDS AND
CAPACITIES, Information, Recommended
Lubricants and Fluids
CAUTION: If a sensor is removed for any
reason, a NEW sensor bush must be fitted.
Remove
10. Push sensor through bush until it touches exciter
ring. Sensor will be ’knocked back’ to correct
position when vehicle is driven.
1.
2.
Disconnect battery negative lead.
Disconnect sensor electrical connections,
located above rear axle.
11. Secure harness in position.
12. Reconnect sensor electrical connection.
13. Clear error code. See Fault diagnosis, Fault
Diagnosis Procedure
3.
Remove sensor from its locating clip.
Drive vehicle to ensure ABS warning light is
extinguished.
4.
5.
Remove bolts securing mudshield.
Using a suitable lever, pry sensor from mounting
bush.
6.
Release harness cable ties, remove sensor lead
from vehicle.
NOTE: The two rear sensor leads are
integral with pad wear harness. In case of
sensor failure complete harness must be
changed.
7.
Remove sensor bush.
REPAIR
9
| Categories | Land Rover, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1995 |
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Name | Range Rover Classic |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)