COOLING SYSTEM
28.
Secure steering pump and bracket to auxiliary
mounting bracket.
THERMOSTAT
29.
30.
Fit steering pump pulley.
Fit drive belt See ELECTRICAL, Repair,
Auxiliary drive belt .
Service repair no - 26.45.01
Remove
31.
32.
Fit fan cowl See Fan cowl .
Fit viscous fan unit See Viscous coupling and
fan .
1. Partially drain cooling system, until coolant level
is below thermostat housing.
33.
34.
35.
Fit intercooler top hose.
Fit radiator top hose.
Refill cooling system. See Adjustment, Drain
and refill cooling system
Reconnect battery.
2. Disconnect top hose from outlet elbow.
36.
3.
Disconnect electrical connections to water
temperature switch.
4.
5.
Unscrew 2 bolts and remove outlet elbow.
Withdraw thermostat. Note 88° C rating of
thermostat.
6.
Place thermostat in a container half full of water.
Heat water and observe temperature at which
thermostat begins to open. Thermostat is
satisfactory if it opens between 85° - 89° C.
Refit
7.
8.
Fit thermostat with jiggle pin/vent hole upwards.
Secure outlet elbow to thermostat housing.
Tighten bolts to 25 Nm (18 lbf/ft).
9.
10.
11.
Fit water temperature switch connections.
Fit top hose to outlet elbow.
Refill cooling system. See Adjustment, Drain
and refill cooling system
REPAIR
5
| Categories | Land Rover, Land Rover Defender |
|---|---|
| Tags | Land Rover |
| Model Year | 1996 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Name | Defender 300 Tdi |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)